Pumping and hydro-pneumatic system contractor — constant pressure across every floor

Scope

Scope of work

Pump sets are sized from the total head — static lift, friction through the network and the residual pressure required at the furthest outlet — and the peak flow, with a duty and standby arrangement, VFD control for constant pressure, and pressure vessels sized to limit cycling. Transfer pumps are designed for the underground-to-overhead lift and booster sets for the zones the tank height cannot serve. We supply and install the pumps, panels, VFDs, vessels, manifolds, valves and the pump-room pipework.

How it is delivered — and what you receive

Each set is commissioned against its design curve — pressure and flow measured at the pump and at the furthest outlet — and the VFD set-points tuned so pressure holds through the demand range without hunting. Standby changeover and dry-run protection are tested. The client receives the commissioning readings, the panel schematics and the set-point record, which is what the AMC engineer needs to keep the system where it was left.

Sources and standards

• IS 1172 (1993 (reaffirmed)) — IS 1172 — Code of Basic Requirements for Water Supply, Drainage and Sanitation. Bureau of Indian Standards. Publisher.Per-capita water requirements and sanitary provisions by building type.
• NBC 2016 Part 9 (2016) — National Building Code of India 2016, Part 9 — Plumbing Services. Bureau of Indian Standards. Publisher.Water supply, drainage and sanitation, and the per-capita demand basis.

Standards are cited to support the technical statements on this page. Where a standard has been revised, the edition shown is the one verified at the time of review; the edition in force for a project is the one the authority applies.

Before you ask us to quote: the Plumbing buyer's guide lists what to have ready, what drives cost and timeline, and the approvals that usually apply.